That is way beyond my comprehension all I want to do is make the pi a controller of ESP8266/ESP01S relay modules.
What I want to do is GPIO pin 4 changes state and that sends a signal via wifi to the relay module causing the relay to change state.
No other device to be connected.
Th pi is the master and the modules are slaves.
When I try to set up an access point the pi connects to my wifi network and I cannot get it to stop doing it.
Following some things on the net I have emptied a config file that controls this but it still does it.
What I want to do is GPIO pin 4 changes state and that sends a signal via wifi to the relay module causing the relay to change state.
No other device to be connected.
Th pi is the master and the modules are slaves.
When I try to set up an access point the pi connects to my wifi network and I cannot get it to stop doing it.
Following some things on the net I have emptied a config file that controls this but it still does it.
Statistics: Posted by GAP — Thu Jan 23, 2025 3:58 am
