If it is already confusing to refer ALT0 function instead of signal name, is the instruction below clear to everyone else?
Usage: dtoverlay=i2c1,<param>=<val>
Params: pins_2_3 Use pins 2 and 3 (default)
pins_44_45 Use pins 44 and 45
dtoverlay help says that i2c1 is either on pins 2/3 or 44/55. But these are GPIO-ports. Not pins.
Usage: dtoverlay=i2c1,<param>=<val>
Params: pins_2_3 Use pins 2 and 3 (default)
pins_44_45 Use pins 44 and 45
dtoverlay help says that i2c1 is either on pins 2/3 or 44/55. But these are GPIO-ports. Not pins.
Statistics: Posted by gotaf80307 — Mon Mar 18, 2024 5:35 pm