Thanks for the answers!
I tried to get the "dance" working, but to no avail. Image may be NSFW.
Clik here to view.
I could not even get the reload interrupt to trigger when phase was set strangely.
On many occasions now I have seen that one channel disappears for a while (maybe 30 seconds), before suddenly reappearing again. I suspect that the counter if wandering outside the range, causing the overflow not to happen for a while. It always reappears sooner or later though! Image may be NSFW.
Clik here to view.
Fortunately for this use case, it need one pulse to appear just after the other. So by configuring one as leading edge and the other as trailing edge, I could solve my problem at hand.
Thanks again for the swift and excellent support!
/Mikael
I tried to get the "dance" working, but to no avail. Image may be NSFW.
Clik here to view.
I could not even get the reload interrupt to trigger when phase was set strangely.
On many occasions now I have seen that one channel disappears for a while (maybe 30 seconds), before suddenly reappearing again. I suspect that the counter if wandering outside the range, causing the overflow not to happen for a while. It always reappears sooner or later though! Image may be NSFW.
Clik here to view.
Fortunately for this use case, it need one pulse to appear just after the other. So by configuring one as leading edge and the other as trailing edge, I could solve my problem at hand.
Thanks again for the swift and excellent support!
/Mikael
Statistics: Posted by Micke — Wed Jul 31, 2024 2:29 pm
