Looking for some help. I have a very good installation of myMPD using the above with an I2C audio hat. I am looking to repeat the operation using the headless PiZero2W and only an inexpensive bluetooth speaker.
So far, I have been able to get the speaker to connect and output the speaker test (speaker-test -c2 -twav -l2). but I have not yet hit on the proper combination of configuration for the audio_output section in mpd.conf. I have seen a few solutions that use "blueman", but it is not offered in buster. The other threads I have seen use pulseaudio but do not provide any details on any modifications to the second and third level connector files.
I was really hoping to have a small and super portable streaming device to take camping and on the boat.
Thanks in advance for the help.
So far, I have been able to get the speaker to connect and output the speaker test (speaker-test -c2 -twav -l2). but I have not yet hit on the proper combination of configuration for the audio_output section in mpd.conf. I have seen a few solutions that use "blueman", but it is not offered in buster. The other threads I have seen use pulseaudio but do not provide any details on any modifications to the second and third level connector files.
I was really hoping to have a small and super portable streaming device to take camping and on the boat.
Thanks in advance for the help.
Statistics: Posted by jachaney — Wed May 29, 2024 9:51 pm